P268A-ECU INTERNAL FAILURE
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
With the ignition on.
-
Set Condition:
The Powertrain Control Module (PCM) detects that one or more of the Fuel Injector values have not been programmed.
Possible Causes |
|---|
| INJETOR QUANTITY ADJUSTMENT NOT PROGRAMMED INTO THE POWERTRAIN CONTROL MODULE |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
DTC IS ACTIVE
| 1. | This DTC will set if the PCM or a Fuel Injector was replaced and the Injector Quantity Adjustment function was not performed. |
View repair
Yes
- Program the Injector Quantity Adjustment into the Powertrain Control Module.
- Perform the PCM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).