P1697-EMR (SRI) MILEAGE NOT STORED
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
Continuously with the ignition on.
-
Set Condition:
The Powertrain Control Module (PCM) Odometer mileage has not been programmed into the PCM.
Possible Causes |
|---|
| PCM ODOMETER MILEAGE NOT PROGRAMMED |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
PCM ODOMETER MILEAGE NOT PROGRAMMED
| 1. | Turn the ignition on. |
| 2. | With the scan tool, attempt to perform the Program PCM Odometer function under the PCM/ECM REPROGRAMMING Procedure. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure). |
| 3. | Using the scan tool, clear DTCs. |
| 4. | Start the engine. |
| 5. | Allow the engine to reach normal operating temperature. |
| 6. | With the scan tool, select View DTCs. |
Is the DTC Active at this time?
Yes
- Replace and program the Powertrain Control Module in accordance with the Service Information. (Refer to 08 - Electrical/8E - Electronic Control Modules/MODULE, Powertrain Control - Removal) .
- Perform the POWERTRAIN VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
No
- The SRI mileage has been successfully programmed into the PCM. Test is complete.
- Perform the POWERTRAIN VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).