U0001-CAN C BUS
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
Continuously when the ignition is on.
Battery voltage between 10 and 16 volts.
Ignition Off Draw (IOD) fuse installed.
-
Set Condition:
The controller detects an open, short to ground or a short to voltage on the CAN C Bus circuit.
Possible Causes |
|---|
| CAN C BUS CIRCUITS OPEN OR SHORTED |
| DTCS RELATED TO BATTERY VOLTAGE, IGNITION, OR VIN MESSAGES |
| TOTALLY INTEGRATED POWER MODULE POWER AND GROUND |
| TOTALLY INTEGRATED POWER MODULE (TIPM) |
| MODULE THAT SET THIS DTC |
VERIFY DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE
| NOTE: | Make sure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding. |
| 1. | Turn the ignition on. |
| 2. | With the scan tool, read active DTCs. |
Is this DTC active?
Yes
- (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Diagnosis and Testing) and perform the U0001-CAN C Bus diagnostic procedure.
No
- (Refer to 29 - Non-DTC Diagnostics/Communication - Diagnosis and Testing) and perform the Stored Lost Communication DTCs diagnostic procedure.