P0630-VIN NOT PROGRAMMED IN PCM
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
At initialization.
-
Set Condition:
The VIN has not been programmed into the PCM. One Trip Fault. Three good trips to turn off the MIL.
Possible Causes |
|---|
| PROGRAMMING VIN INTO PCM |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
PROGRAMMING VIN INTO THE PCM
| 1. | Ignition on, engine not running. |
| 2. | Using the scan tool, program VIN into the PCM. |
| 3. | Start the engine. |
| NOTE: | If the engine will not start, crank the engine over for 15 seconds. Crank at least two times with the ignition switch returning to the off position each time. |
| 4. | Allow the engine to reach normal operating temperature. |
| 5. | With the scan tool, select View DTCs. |
Does the DTC reset?
Yes
- Replace and program the Powertrain Control Module in accordance with the Service Information. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
- Perform the POWERTRAIN VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
No
- The VIN has been successfully programmed into the PCM. Test is complete.
- Perform the POWERTRAIN VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).