P0632-ODOMETER NOT PROGRAMMED IN PCM
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
Ignition on.
-
Set Condition:
Odometer is not programed into the Powertrain Control Module (PCM). One Trip Fault. Three good trips to turn off the MIL.
Possible Causes |
|---|
| PROGRAMMING MILEAGE INTO THE PCM |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
PROGRAMMING MILEAGE INTO THE PCM
| 1. | Ignition on, engine not running. |
| 2. | With the scan tool, erase DTCs. |
| 3. | Using a scan tool, program the mileage into the PCM. |
| 4. | Start the engine. |
| 5. | Allow the engine to reach normal operating temperature. |
| 6. | With the scan tool, select View DTCs. |
Does the DTC reset?
Yes
- Replace and program the Powertrain Control Module in accordance with the Service Information. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
- Perform the POWERTRAIN VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
No
- The mileage has been successfully programmed into the PCM. Test is complete.
- Perform the POWERTRAIN VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).