C2209-00-TIRE PRESSURE MONITOR INTERNAL
| NOTE: |
Check for and remove any non-FCC compliant components before beginning this diagnostic procedure. |
-
When Monitored:
Ignition on. The Tire Pressure Monitoring (TPM) Module monitors its internal microprocessors for correct operation.
-
Set Condition:
If the Tire Pressure Module detects an internal fault, the DTC is set.
Possible Causes |
|---|
| NON-FCC COMPLIANT COMPONENTS |
| TIRE PRESSURE MONITORING (TPM) MODULE - INTERNAL FAULT |
TPM INTERNAL FAILURE DTC PRESENT
| 1. | Turn the ignition on. |
| 2. | With the scan tool, read DTCs. |
| 3. | With the scan tool, erase stored DTCs. |
| 4. | Turn the ignition off. |
| 5. | Turn the ignition on. |
| 6. | With the scan tool, read DTCs. |
Does the scan tool display TIRE PRESSURE MODULE INTERNAL FAILURE?
Yes
- Replace the Tire Pressure Monitoring (TPM) Module in accordance with the Service Information. (Refer to 22 - Tires and Wheels/Tire Pressure Monitoring/MODULE, Tire Pressure Monitoring (TPM) - Removal).
- Perform the TPM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Tire Pressure (TPM) - Standard Procedure).
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the TPM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Tire Pressure (TPM) - Standard Procedure).