2014 Jeep Wrangler JK Factory Service Manual 28 - DTC-Based Diagnostics

B230D-REAR WIPER PARK SWITCH INPUT CIRCUIT LOW (STUCK LOW)



For a complete wiring diagram, refer to the Wiring Information.



Possible Causes

(W17) REAR WIPER PARK SWITCH SENSE CIRCUIT SHORTED TO GROUND
REAR WIPER MOTOR
TOTALLY INTEGRATED POWER MODULE

1. INTERMITTENT CONDITION


1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. Turn the Rear Wipers on then off.
4. With the scan tool, read DTCs.


Does the scan tool display this DTC as active?

Yes


No


2. REAR WIPER MOTOR



1. Turn the ignition off.
2. Disconnect the Rear Wiper Motor harness connector.
3. Turn the ignition on.
4. With the scan tool, read the Rear Wiper Park Switch Sense.


Does the Rear Wiper Park Switch Sense display: True?

Yes


No


3. CHECK (W17) REAR WIPER PARK SWITCH SENSE CIRCUIT FOR A SHORT TO GROUND



1. Turn the ignition off.
2. Disconnect the TIPM C7 harness connector.
3. Measure the resistance between ground and the (W17) Rear Wiper Park Switch Sense Circuit.


Is the resistance above 10k Ohms?

Yes


No