|
PART
|
COLOR
|
LOCATION
|
DIAGRAM
|
|
12 VOLT CONSTANT
|
Connect to BATTERY ONLY
|
|
|
|
STARTER
|
YELLOW (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
STARTER 2
|
PURPLE/BROWN (-), See NOTE #2
|
@ IGNITION SWITCH HARNESS, See DIAGRAM
|
30643_VOYAGER_CHRYSLER MINI VAN STARTER 2 DIAGRAM.pdf
|
|
IGNITION 1
|
PINK/WHITE (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
IGNITION 2
|
N/A
|
@ IGNITION SWITCH HARNESS
|
|
|
IGNITION 3
|
N/A
|
|
|
|
ACCESSORY/HEATER BLOWER 1
|
N/A
|
|
|
|
ACCESSORY/HEATER BLOWER 2
|
N/A
|
|
|
|
KEYSENSE
|
N/A
|
|
|
|
PARKING LIGHTS ( - )
|
WHITE/BROWN (-), See NOTE #3
|
@ HEADLIGHT SWITCH, See DIAGRAM
|
26500_VOYAGER_CHRYSLER PARKING LIGHT DIAGRAM.pdf
|
|
PARKING LIGHTS ( + )
|
N/A
|
|
|
|
POWER LOCK
|
PURPLE/GREEN (1-Wire Door Lock System), See NOTE #4
|
@ BCM, Connector 3, Pin 21, See DIAGRAM
|
17044_VOYAGER_CHRYSLER MINI VAN 01 - UP 1 WIRE JBS UNITS.pdf
|
|
POWER UNLOCK
|
Same wire, See DIAGRAM
|
See DIAGRAMS
|
32591_VOYAGER_CHRYSLER COUPE and SEDAN 1 WIRE ALERT SHELBY UNITS.pdf
|
|
LOCK MOTOR WIRE
|
TAN/WHITE (5-WIRE TYPE)
|
@ BCM, C2, Pin 10, See NOTE #6
|
|
|
DOOR TRIGGER
|
See NOTE #5
|
@ BCM, Connector 3, See NOTE #6
|
|
|
DOMELIGHT SUPERVISION
|
PURPLE (-)
|
@ BCM, Connector 3, Pin 6, See NOTE #6
|
|
|
TRUNK RELEASE
|
PURPLE/TAN (-), See NOTE #8
|
@ BCM, Connector 2, Pin 6, See NOTE #6
|
26500_VOYAGER_CHRYSLER MINI VAN 01 - UP HATCH POP DIAGRAM.pdf
|
|
SLIDING POWER DOOR
|
PURPLE/BLUE (-), See NOTE #9
|
@ BCM, Connector 3, Pin 1, See NOTE #6
|
26500_VOYAGER_CHRYSLER MINI VAN 01 - UP SLIDING DOOR DIAGRAM.pdf
|
|
HORN
|
BLACK/RED (-)
|
@ STEERING COLUMN HARNESS
|
|
|
TACH
|
GRAY or GRAY/RED (AC)
|
@ IGNITION COIL PACK
|
|
|
WAIT TO START LIGHT
|
N/A
|
|
|
|
BRAKE
|
WHITE/TAN (+)
|
@ SWITCH ABOVE BRAKE PEDAL
|
|
|
FACTORY ALARM DISARM
|
PURPLE/LIGHT BLUE (-), See NOTE #10
|
@ BCM, Connector 3 Pin 14, See NOTE #6
|
|
|
ANTI-THEFT
|
CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), See NOTE #1
|
@ IGNITION SWITCH TUMBLER
|
|
|
NOTES
|
NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
website.
NOTE #2: To Remote Start this vehicle and turn on the AC/Heater will require an extra relay part
#775 and a (-)Negative thru a 180 Ohm Resistor, THIS MUST BE INSTALLED to
operate in Remote Start Mode, to connect, See DIAGRAM.
NOTE #3; To turn on the PARKING LIGHTS requires a (-)Negative thru a 2000 Ohm resistor and
an extra relay part #775, to connect, See DIAGRAM
NOTE #4: This vehicle uses a 1-Wire Door Locking System requiring a (-)Negative thru a 5200
Ohm for LOCK, and a (-)Negative thru a 2000 Ohm Resistor for UNLOCK, some units
will also require 2 extra relays part #775, to connect, See DIAGRAMS
NOTE #5: This vehicle uses 4 door pin trigger wires, the DRIVERS DOOR is a PURPLE (-) at PIN
6, the PASSENGERS DOOR is a PURPLE/WHITE (-) PIN 7, the DRIVERS SIDE SLIDING
DOOR is a PURPLE/GREY, PIN 8 and the PASSENGER SIDE SLIDING DOOR is a
PURPLE/YELLOW, PIN 5. When connecting to an ALARM SYSTEM use all 4 wires and
DIODE ISOLATE. See DIAGRAM
NOTE #6: The BCM (Body Control Module is located in the DRIVERS KICK PANEL, near the
PARKING BRAKE. The BCM has 5 Plugs, (1) 6-Pin Plug, and (4) 34-Pin PLugs.
NOTE #7: The Rear Hatch Pop requires a (-) Negative thru a 1500 Ohm Resistor and an extra
relay part #775, to connect, See DIAGRAM
NOTE #8: The SLIDING DOORS require a (-)Negative thru a 1500 Ohm Resistor for the
DRIVERS door and a (-)Negative thru a 2700 Ohm Resistor for the PASSANGER
door, units will also require an extra relay for each door part #775, See DIAGRAM.
NOTE #9: The TACH wire on the 2.4L is BLUE/GREEN or BLUE/TAN. On the 3.3L and 3.8L use
the BLUE/GREEN, BLUE/TAN or BLUE/ORANGE (AC)
NOTE #10: This vehicle will DISARM with a (-)Negative thru a 9000 Ohm resistor, MUST use
SINGLE pulse to DISARM and a DOUBLE pluse on this wire will also UNLOCK.
|