BMW


 


316i, (E30), 1766 cc, 1987-89, Engine Code 18 4K/E A/B

Ignition Data
Ignition system type: El-i
Ignition coil make/type: Bo/0 221 122 319
Supply voltage: 10.8 - Volts without ballast resistor
Primary resistance: 0.82 Ohms
Secondary resistance: 8250 Ohms
Distributor make/type: Bo/0 237 002 111
Contact breaker gap/air: 0.35-0.70 mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 26/3500 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 31/3500 Deg eng/rpm (without vacuum)
Timing mark location: Flywheel
No 1 plug location: Pulley
Firing Order: 1-3-4-2
Spark plug make: Bosch
Spark plug type: W8DC
Electrode gap: 0.7-0.8 mm

Fuel System
Fuel type: L/U
Fuel pump type/pressure: Elec/2.94-3.06 bar
Engine idle speed: 850-900 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.2-1.2 Vol %

Engine Data
Valve clearance - inlet: 0.20 c mm (cold)
Valve clearance - exhaust: 0.20 c mm (cold)
Compression pressure: 10-11 bar
Oil pressure: 4-6/- bar/eng/rpm
Radiator pressure cap: 0.9-1.1 bar/type
Drive belt 1 - size: 9.5x875 KDB875 mm/type
Drive belt 2 - size: 9.5x810 KDB810 mm/type

Electrical System
Alternator output: 80/2500 Amps/eng/rpm
Regulated output: 13.5-14.2 Volts
Battery: 12/44 V/Ah
Starter motor make/type: Bo/0 001 469 617

Other Data
Clutch operation type: Hyd
Clutch adjustment: S/Adj. mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 1.8(26)f 2.0(28)r bar (psi)


316i, (E30), 1596 cc, 1988-92, Engine Code 16 4E 1

Ignition Data
Ignition system type: El-ecu
Ignition coil make/type: Bo/0 221 118 335
Supply voltage: 10.8 - Volts without ballast resistor
Primary resistance: 0.5 Ohms
Secondary resistance: 8250 Ohms
Distributor make/type: Bo/0 261 200 174
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: n / a Deg eng/rpm (without vacuum)
Ignition Timing - leaded: n / a Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-3-4-2
Spark plug make: Bosch
Spark plug type: F8LCR
Electrode gap: 0.7 mm

Fuel System
Fuel type: L/U +Cat
Fuel pump type/pressure: Elec/2.94-3.06 bar
Engine idle speed: 800  40 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.7  0.5 Vol %

Engine Data
Valve clearance - inlet: Hyd
Valve clearance - exhaust: Hyd
Compression pressure: 10-11 bar
Oil pressure: 4.0-4.3/- bar/eng/rpm
Radiator pressure cap: 0.9-1.1 bar/type
Drive belt 1 - size: 9.5x1013 KDB101 mm/type
Drive belt 2 - size: 9.5x810 KDB810 mm/type

Electrical System
Alternator output: 80/2500 Amps/eng/rpm
Regulated output: 13.5-14.2 Volts
Battery: 12/44 V/Ah
Starter motor make/type: Bo/0 001 108 065

Other Data
Clutch operation type: Hyd
Clutch adjustment: S/Adj. mm
Cambelt failure: Damage
Cambelt Part Number: 11311734608
Tyre pressures: 1.8(26)f 2.0(28)r bar (psi)


318i, (E30), 1766 cc, 1982-86, Engine Code M10-B18

Ignition Data
Ignition system type: El-i
Ignition coil make/type: Lu/DLB101
Supply voltage: 10.8 - Volts without ballast resistor
Primary resistance: 0.6-1.0 Ohms
Secondary resistance: 8250 Ohms
Distributor make/type: Bo/0 237 005 008
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 18/2300 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 25/2300 Deg eng/rpm (without vacuum)
Timing mark location: Flywheel
No 1 plug location: Pulley
Firing Order: 1-3-4-2
Spark plug make: Bosch
Spark plug type: W8DC
Electrode gap: 0.7 mm

Fuel System
Fuel type: L/U
Fuel pump type/pressure: Elec/4.5-5.2 bar
Engine idle speed: 900  50 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.5-1.5 Vol %

Engine Data
Valve clearance - inlet: 0.20 c mm (cold)
Valve clearance - exhaust: 0.20 c mm (cold)
Compression pressure: 10-12 bar
Oil pressure: 4-6/- bar/eng/rpm
Radiator pressure cap: 0.9-1.15 KRB250 bar/type
Drive belt 1 - size: 9.5x875 KDB875 mm/type
Drive belt 2 - size: n / a mm/type

Electrical System
Alternator output: 80/2500 Amps/eng/rpm
Regulated output: 13.5-14.2 Volts
Battery: 12/50 V/Ah
Starter motor make/type: Bo/0 001 311 100

Other Data
Clutch operation type: Hyd
Clutch adjustment: S/Adj. mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 1.8(26)f 2.0(28)r bar (psi)


318i S 16V, (E30), 1796 cc, 1989-91, Engine Code 18 4S 1

Ignition Data
Ignition system type: El-ecu
Ignition coil make/type: Bo/0 221 504 414
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.3-0.5 Ohms
Secondary resistance: n / a Ohms
Distributor make/type: Bo/0 261 200 175
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: n / a Deg eng/rpm (without vacuum)
Ignition Timing - leaded: n / a Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-3-4-2
Spark plug make: Bosch
Spark plug type: F03DAR
Electrode gap: 0.9 mm

Fuel System
Fuel type: L/U +Cat
Fuel pump type/pressure: Elec/2.94-3.06 bar
Engine idle speed: 850  40 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.7  0.5 Vol %

Engine Data
Valve clearance - inlet: Hyd
Valve clearance - exhaust: Hyd
Compression pressure: 10-11 bar
Oil pressure: 4.0-4.3/6000 bar/eng/rpm
Radiator pressure cap: 0.9-1.1 bar/type
Drive belt 1 - size: n / a mm/type
Drive belt 2 - size: n / a mm/type

Electrical System
Alternator output: 65/2500 Amps/eng/rpm
Regulated output: 13.5-14.2 Volts
Battery: 12/50 V/Ah
Starter motor make/type: Bo/1.4 kW

Other Data
Clutch operation type: Hyd
Clutch adjustment: S/Adj. mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 1.8(26)f 2.0(28)r bar (psi)

Back to page top or return to menu