DTC Troubleshooting: 87-32
DTC Troubleshooting: 87-32
| DTC 87-32: | Side Airbag Cutoff Indicator Stays On/OFF |
| 1. | Erase the DTC memory. |
| 2. | Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off. Does the SRS indicator stay on? YES - Go to 3. NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Faliure. |
| 3. | Turn the ignition switch OFF. Make sure nothing is on the front passenger's seat. |
| 4. | Disconnect the OPDS unit harness 8P connector (A) from the OPDS unit. A |
| 5. | Turn the ignition switch ON (II). |
| 6. | Check for voltage between the No. 3 terminal of the OPDS unit harness 8P connector and body ground. There should be battery voltage. OPDS UNIT HARNESS 8P CONNECTORWire side of female terminalsORN/BLUIs there battery voltage? YES - Faulty OPDS unit; replace the OPDS unit. NO - Go to 7. |
| 7. | Turn the ignition switch OFF. |
| 8. | Disconnect the gauge assembly connector (30P) (A) from the gauge assembly. A |
| 9. | Check resistance between the No. 3 terminal of the OPDS unit harness 8P connector and body ground. There should be an open circuit, or at least 1 MW. OPDS UNIT HARNESS 8P CONNECTORWire side of female terminalsORN/BLUIs the resistance as specified? YES - Go to 10. NO - Short to ground in the OPDS unit harness, floor wire harness, or dashboard wire harness; replace the faulty harness. |
| 10. | Check the resistance between the No. 3 terminal of the OPDS unit harness 8P connector and the No. 29 terminal of gauge assembly connector (30P). There should be 0-1.0 W. GAUGE ASSEMBLY CONNECTOR (30P)Wire side of female terminalsORN/BLUOPDS UNIT HARNESS8P CONNECTOR Is the resistence as specified? YES - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. NO - Open in the ORN/BLU wire in the OPDS unit harness, floor wire harness, or dashboard wire harness; replace the faulty harness.n |