Honda Accord ESM 2003 · Service Manual Service Manual 2003

Combination Light Switch Test/Replacement (LHD)

Combination Light Switch Test/Replacement

LHD type:


1.Remove the dashboard lower cover.

2.Remove the steering column covers.

3.Disconnect the 12P connector (A) from the wiper/washer switch (B).

SDA3A00J32100017101FHAD01AB

4.Remove the two screws, then slide out the combination light switch (A).

SDA3A00J32100017101FHAD02AWire side of
female terminals

5.Inspect the connector terminals to be sure they are all making good contact.

  • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
  • If the terminals look OK, check for continuity between the terminals in each switch position according to the tables.
    • If there is no continuity replace switch.

SEA3EG0J32100017101FHAD01RIGHTTerminalPositionOFF7112Headlight switchPassing switchLOWHIGHOFFONLight switch:23412104PositionLEFTNEUTRALTurn signal switch:TerminalFRONT/REAR12115PositionFRONTREARFront/rear fog light switch:Terminal