Carpet Replacement (4D)
Carpet Replacement
SRS components are located in this area. Review the SRS component locations LHD, SRS components locations RHD and the precautions and procedures in the SRS section before performing repairs or service.NOTE:
- Put on gloves to protect your hands.
- Take care not to damage, wrinkle or twist the carpet.
- Be careful not to damage the dashboard or other interior trim pieces.
| 1. | If the side curtain airbag is equipped, disconnect the negative battery cable, and wait at least 3 minutes before beginning work. |
| 3. | Remove the front seat belt lower anchor bolt, both sides. |
| 4. | Push the knob (A) back to release the hook (B) then pull up the accel pedal (C). ABC |
| 5. | Detach the clips, then remove the footrest (A). LHD is shown; RHD is similar.  Fastener Locations: Clip, 2A |
| 6. | M/T Model: Remove the bolts, then remove the center console bracket (A). Fastener Locations: Bolt, 26 x 1.0 mm9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)A |
| 7. | Disconnect the antenna lead (A) and antenna connector (B). If equipped, disconnect the side curtain airbag subharness connector (C), and release the harness clamp (D). Detach the harness clips (E), and on A/T model, harness clips (F). LHD (A/T):  ABCEFEELHD (M/T):  ABCEEEDRHD:  ABCEEFEF |
| 8. | Remove the bolts securing the change lever bracket or select lever bracket (A). Fastener Locations: Bolt, 4A8 x 1.25 mm22 N·m (2.2 kgf·m, 16 lbf·ft) |
| 9. | Release the clip (A) from middle of the carpet (B). Fastener Locations: Clip, 1A: Hook, 4CCCACBDC |
| 10. | Release the hooks (C) with a flat-tip screwdriver, and the fastener (D), then remove the carpet. |
| 11. | Install the carpet in the reverse order of removal, and note these items:
With side curtain airbag:
|