Interior Trim Removal/Installation - Quarter Pillar Area (5D)

Interior Trim Removal/Installation - Quarter Pillar Area

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before performing repairs or service.

NOTE:

• Put on gloves to protect your hands.
  
• When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  
• Take care not to bend or scratch the trim and panels.
  

1.	Remove the rear side trim panel.

2.	Remove the trim as shown:

3.

Install the trim in the reverse order of removal, and note these items: If the side curtain airbag have deployed, be sure to check the removed trim pieces for damage before reinstallation, and if necessary, replace them with new ones. If the side curtain airbag have not deployed, removed trim pieces should still be checked for damage, and replace them with new ones if necessary. Make sure the top of the trim overlaps with the headliner correctly. Make sure the quarter pillar trim hooks are installed into holes in the rear pillar bracket securely. Push the clip portions into place securely. Fastener LocationsA: Clip, 9B: Clip, 1ROOF END TRIMQUARTER PILLAR TRIMC: Clip, 2HOOKHOOKHOOKTAILGATE HINGE COVERHOOKSHOOKSHOOKSREAR PILLAR BRACKETAAAAACCAAAAB