FRAME WIRE > INSTALLATION

1. INSTALL FRAME WIRE

2. INSTALL INVERTER RESERVE TANK ASSEMBLY

3. CONNECT HYBRID BATTERY JUNCTION BLOCK ASSEMBLY

4. CHECK HIGH VOLTAGE CABLE CONNECTION CONDITION

5. CONNECT CABLE TO AUXILIARY BATTERY TERMINAL

6. INSTALL UPPER HYBRID BATTERY COVER SUB-ASSEMBLY

7. INSTALL NO. 1 HYBRID BATTERY EXHAUST DUCT

8. INSTALL NO. 1 HYBRID BATTERY INTAKE DUCT

9. INSTALL REAR FLOOR BOARD SPACER

10. INSTALL HYBRID VEHICLE BATTERY SHIELD SHEET

11. INSTALL REAR NO. 1 FLOOR BOARD

12. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY

13. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY

14. INSTALL REAR SEAT SIDE GARNISH RH

15. INSTALL REAR DOOR SCUFF PLATE RH

16. INSTALL REAR SEATBACK ASSEMBLY RH

17. INSTALL FRONT SUSPENSION MEMBER BRACE REAR RH

18. INSTALL FRONT CENTER FLOOR COVER RH (w/ Cover)

19. INSTALL FRONT FLOOR COVER RH (w/ Cover)

20. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

21. INSTALL FRONT EXHAUST PIPE ASSEMBLY

22. INSTALL INVERTER WITH CONVERTER ASSEMBLY

23. INSTALL DECK FLOOR BOX LH (w/o Woofer)

24. INSTALL REAR NO. 4 FLOOR BOARD (w/ Woofer)

25. INSTALL REAR NO. 4 FLOOR BOARD (w/o Woofer)

26. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

27. INSTALL SERVICE PLUG GRIP