ENTRY AND START SYSTEM (for Start Function) > Power Source Mode does not Change to ON (IG and ACC)

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - POWER MANAGEMENT CONTROL ECU)

CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND)

READ VALUE USING INTELLIGENT TESTER

READ VALUE USING INTELLIGENT TESTER

CHECK POWER MANAGEMENT CONTROL ECU

CONFIRMATION TEST

INSPECT POWER SWITCH

CHECK HARNESS AND CONNECTOR (POWER SWITCH - POWER MANAGEMENT CONTROL ECU AND BODY GROUND)

CHECK FOR DTC