BRAKE BOOSTER (for RHD) > INSTALLATION

1. INSTALL BRAKE BOOSTER GASKET

2. INSTALL BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

3. CONNECT RESERVOIR TUBE ASSEMBLY

4. SEPARATE BRAKE MASTER CYLINDER RESERVOIR WITH BRACKET

5. BLEED RESERVOIR TUBE ASSEMBLY

6. INSTALL BRAKE MASTER CYLINDER RESERVOIR WITH BRACKET

7. INSTALL RESERVOIR TUBE ASSEMBLY

8. INSTALL PUSH ROD PIN

9. INSTALL BRAKE PEDAL RETURN SPRING

10. FILL RESERVOIR WITH BRAKE FLUID

11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

12. BLEED BRAKE SYSTEM

13. INSPECT AND ADJUST BRAKE PEDAL

14. OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR

15. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

16. INSTALL SUSPENSION TOWER DAMPER (w/ Suspension Tower Damper)

17. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

18. INSTALL COWL BODY MOUNTING REINFORCEMENT RH

19. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

20. INSTALL NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

21. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY