CONDENSER > INSTALLATION

1. INSTALL COOLER CONDENSER ASSEMBLY

2. INSTALL NO. 2 FAN SHROUD

3. INSTALL NO. 1 INVERTER BRACKET

4. CONNECT NO. 1 INVERTER COOLING HOSE

5. CONNECT NO. 5 INVERTER COOLING HOSE

6. CONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY

7. CONNECT COOLER REFRIGERANT DISCHARGE HOSE

8. INSTALL HOOD LOCK SUPPORT SUB-ASSEMBLY

9. INSTALL HIGH PITCHED HORN ASSEMBLY

10. INSTALL LOW PITCHED HORN ASSEMBLY

11. INSTALL COOL AIR INTAKE DUCT RETAINER SUB-ASSEMBLY

12. INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)

13. INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)

14. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

15. INSTALL FRONT BUMPER ASSEMBLY

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

17. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

18. INSTALL DECK FLOOR BOX RH

19. INSTALL REAR NO. 3 FLOOR BOARD

20. INSTALL REAR DECK FLOOR BOX

21. INSTALL REAR NO. 2 FLOOR BOARD

22. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT

23. ADD COOLANT (for Inverter)

24. INSPECT FOR COOLANT LEAK (for Inverter)

25. WARM UP COMPRESSOR

26. INSPECT FOR REFRIGERANT LEAK

27. ADJUST HOOD SUB-ASSEMBLY

28. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)