Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH

for Preparation Click here


DESCRIPTION

If the manual up and down functions operate normally but the auto up and down functions do not, the fail-safe mode may be functioning.
If power window initialization (Click here) has not been performed, the auto up and down functions will not operate.

HINT:
If the pulse sensor built into the power window regulator motor assembly (for rear RH side) malfunctions, the power window control system enters fail-safe mode. The remote up and down and auto up and down functions cannot be operated during fail-safe mode. However, the power window can be closed by holding the rear power window regulator switch assembly (for RH side) at the auto up position, and opened manually by pushing down the rear power window regulator switch assembly (for RH side).


WIRING DIAGRAM


B203367E89


INSPECTION PROCEDURE

NOTICE:
  1. The power window control system uses a LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Click here). Troubleshoot the power window control system after confirming that the communication system is functioning properly.
  2. If the power window regulator motor assembly (for rear RH side) has been replaced with a new one, initialize the power window control system (Click here).

1.READ VALUE USING INTELLIGENT TESTER (RR-Door Motor)

  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / RR-Door Motor / Data List.

  1. Read the Data List according to the display on the intelligent tester.

    RR-Door Motor (Power Window Regulator Motor Assembly (for Rear RH Side)) 
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    RR Door P/W Auto SW
    		Rear RH side power window auto switch signal / ON or OFF
    		ON: Rear RH power window auto switch operated
    OFF: Rear RH power window auto switch not operated
    		-

    OK:
    On the intelligent tester screen, ON or OFF is displayed accordingly.



NG
Go to step 4
OK


2.PERFORM INITIALIZATION (for Rear RH Side)

  1. Initialize the power window regulator motor assembly (for rear RH side) (Click here).


NEXT


3.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)

  1. Check that the rear RH side door power window moves when the auto up and down functions of the rear power window regulator switch assembly (for RH side) are operated (Click here).

    OK:
    Rear RH side auto up and down functions are normal.



NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH Side) (Click here)
OK

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

4.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH Side)


    B203473E31

  1. Remove the rear power window regulator switch assembly (for RH side) (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    8 (AUTO) - 1 (GND)
    		Auto up or auto down position
    		Below 1 Ω

    Text in Illustration 
    *a
    		Component without harness connected
    (Rear Power Window Regulator Switch Assembly (for RH Side))



NG
REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH Side) (Click here)
OK


5.CHECK HARNESS AND CONNECTOR (REAR RH SIDE SWITCH - REAR RH SIDE MOTOR)

  1. Disconnect the power window regulator motor assembly (for rear RH side) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    L3-8 (AUTO) - L2-4 (AUTO)
    		Always
    		Below 1 Ω
    L3-8 (AUTO) - Body ground
    		Always
    		10 kΩ or higher
    L2-4 (AUTO) - Body ground
    		Always
    		10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH Side) (Click here)