Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT RELAY


  1. Inspect IGCT MAIN relay



      A242430

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      		Condition
      		Specified Condition
      3 - 5
      		Auxiliary battery voltage is not applied across terminals 1 and 2
      		10 kΩ or higher
      3 - 5
      		Auxiliary battery voltage is applied across terminals 1 and 2
      		Below 1 Ω

      If the result is not as specified, replace the relay.