BACK DOOR COURTESY SWITCH > INSTALLATION

for Preparation Click here

HINT:

Make sure to remove the string before installing a new back door lock assembly.

1. Apply MP grease to the sliding parts of the back door lock assembly.
   

2. Install the back door lock assembly with the 3 bolts.
   

   Torque:

   7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

3. Engage the 4 clamps.
   

4. Connect the connector.
   

1. Check that the clearance measurements of areas *a through *l are within each standard range.
   
   

   
   
   
   
   

   Standard Clearance 

   Area	Measurement	Area	Measurement
   *a	5.2 to 8.2 mm (0.205 to 0.323 in.)	*b	0 to 3.0 mm (0 to 0.118 in.)
   *c	5.2 to 8.2 mm (0.205 to 0.323 in.)	*d	4.0 to 7.0 mm (0.157 to 0.276 in.)
   *e	1.2 to 4.2 mm (0.0472 to 0.165 in.)	*f	4.0 to 7.0 mm (0.157 to 0.276 in.)
   *g	1.1 to 4.7 mm (0.0433 to 0.185 in.)	*h	3.25 to 7.25 mm (0.128 to 0.285 in.)
   *i	-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)	*j	3.2 to 7.2 mm (0.126 to 0.283 in.)
   *k	-1.8 to 2.2 mm (-0.0709 to 0.0866 in.)	*l	3.85 to 5.85 mm (0.152 to 0.230 in.)

1. Before adjusting the upper end of the back door up and down or left and right, loosen the bolts.
   

2. Tighten the body side hinge after the adjustment.
   

   Torque:

   19 N*m{ 194 kgf*cm , 14 ft.*lbf }

3. Loosen the 3 bolts.
   

4. Tighten the bolts after the adjustment.
   

   Torque:

   7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

1. Engage the 4 clips to install the rear deck trim cover.
   

1. Engage the 2 guides (B).
   

2. Engage the 2 claws and guide (A) to install the deck trim service hole cover.
   

1. Engage the 6 guides.
   

2. Install the deck floor box LH with the clip.
   

1. Install the rear No. 4 floor board.
   

1. Engage the 2 clips and 3 guides to install the rear No. 4 floor board.
   

1. Engage the 6 guides.
   

2. Install the deck floor box RH with the clip.
   

1. Install the rear No. 3 floor board.
   

1. Install the rear deck floor box.
   

1. Install the rear No. 2 floor board.