WIRELESS DOOR LOCK BUZZER > INSTALLATION

for Preparation Click here

HINT:

1. Use the same procedure for RHD and LHD models.
   
2. The procedure listed below is for an LHD model.
   
3. Perform the procedure on the driver side of the vehicle.
   

1. Engage the clamp to install the wireless door lock buzzer.
   

2. Connect the connector.
   

1. Install the front fender liner RH with the 6 clips and 6 screws.
   

2. Install the bolt.
   

3. Install 2 new grommets.
   

4. Using a 4 mm hexagon wrench, install the 3 screws.
   

5. Install the 2 pin hold clips as shown in the illustration.
   

   Text in Illustration 

   *a	Correct
   *b	Incorrect

   NOTICE:

   Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

Torque:

103 N*m{ 1050 kgf*cm , 76 ft.*lbf }