Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR

OCCUPANT DETECTION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT SEAT ASSEMBLY
(Click here)


2. REMOVE RECLINING ADJUSTER RELEASE HANDLE

HINT:
Use the same procedure as for the driver side .



3. REMOVE FRONT SEAT CUSHION SHIELD

HINT:
Use the same procedure as for the driver side .



4. REMOVE FRONT SEAT INNER BELT ASSEMBLY

  1. Disconnect each connector.

  1. Disengage each clamp under the front seat assembly.



    B265209

  1. Remove the nut and front seat inner belt assembly.



5. REMOVE FRONT SEAT INNER CUSHION SHIELD

HINT:
Use the same procedure as for the driver side .



6. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

HINT:
Use the same procedure as for the driver side .



7. REMOVE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)


    B265212

  1. Remove the 2 hog rings.



    B265210

  1. Remove the 21 hog rings and occupant detection sensor (separate type front seat cushion pad) from the separate type front seat cushion cover.