Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY

FRONT SEAT SIDE AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT AIRBAG ASSEMBLY

CAUTION:
  1. The nuts must not be reused.
  2. Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.

  1. Install the front seat airbag assembly with 2 new nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Engage the 2 clamps to connect the airbag wire harness.



2. INSTALL FRONT SEATBACK COVER
for Manual Seat:
for Power Seat:


3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
for Manual Seat:
for Power Seat:


4. INSTALL AIRBAG WIRE HARNESS (for Manual Seat)

  1. w/ Seat Heater System:

    1. Engage the clamp.

    2. Connect the connector.

  1. Engage the fastener to install the airbag wire harness.

  1. Engage the claw and 3 clamps to install the airbag wire harness.

  1. Install the rubber band.



5. INSTALL AIRBAG WIRE HARNESS (for Power Seat)

  1. w/ Seat Heater System:

    1. Engage the clamp.

    2. Connect the connector.

  1. Engage the fastener to install the airbag wire harness.

  1. Engage the claw and 3 clamps to install the airbag wire harness.

  1. Install the rubber band.



6. INSTALL FRONT SEAT ASSEMBLY
for Manual Seat: (Click here)
for Power Seat: (Click here)


7. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)