Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › INTRUSION SENSOR

INTRUSION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (w/o Sliding Roof)

  1. Install the intrusion sensor (theft warning ultrasonic sensor) to the base with the 4 screws.



    B269165E01

  1. Install the board so that the switch lever securely engages with the hole of the switch knob as shown in the illustration.
    Text in Illustration 
    *1
    		Switch lever
    *2
    		Switch knob

  1. Install the cover with the 7 screws.

  1. Engage the 2 clamps.

  1. Install the 2 screws and connect the connector.



    B269169

  1. Put the tape back to the positions shown in the illustration in order to secure the cord to the map light assembly.



  1. w/ Microphone:

    1. Engage the clamp and connect the connector.



      2. B269167

    2. Put the tape back to the positions shown in the illustration in order to secure the cord to the map light assembly.



2. INSTALL INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (w/ Sliding Roof)

  1. Install the intrusion sensor (theft warning ultrasonic sensor) to the base with the 4 screws.



    B269165E01

  1. Install the board so that the switch lever securely engages with the hole of the switch knob as shown in the illustration.
    Text in Illustration 
    *1
    		Switch lever
    *2
    		Switch knob

  1. Install the cover with the 7 screws.



  1. w/ Microphone:

    1. Engage the clamp and connect the connector.



      2. B269160

    2. Put the tape back to the position shown in the illustration in order to secure the cord to the map light assembly.

  1. Engage the 6 clamps.

  1. Install the 2 screws and connect the connector.



3. INSTALL MAP LIGHT ASSEMBLY

  1. Connect the connector.



    E223659E01

  1. Engage the 3 guides and 4 clips to install the map light assembly as shown in the illustration.

  1. Close the overhead console.