Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RELAY

DOOR CONTROL RELAY > INSTALLATION

for Preparation Click here



1. INSTALL DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY

  1. Install the double lock door control relay assembly with the bolt.



2. INSTALL RADIO TUNER OPENING COVER WITH BRACKET (w/o Audio)

  1. Connect each connector.

  1. Install the radio tuner opening cover with bracket with the 4 bolts <A>.



3. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Audio)

  1. Connect each connector.

  1. Install the radio receiver assembly with bracket with the 4 bolts.



4. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

  1. Connect the connector.



    E220732

  1. Engage the 7 claws to install the air conditioning control assembly.



5. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY

  1. Connect each connector.

  1. Engage the clamp.

  1. Engage the 2 guides and 6 claws to install the integration control and panel assembly.



6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B269928

  1. Turn the shift lever knob clockwise and install the shift lever knob sub-assembly.



7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. Connect each connector.

  1. Engage the clamp.



    B269924

  1. Engage the 12 claws to install the upper console panel sub-assembly.

    NOTICE:
    When installing the upper console panel sub-assembly, make sure not to pinch the wire harness connected to the front end of the remote touch (w/ Navigation System).

  1. Close the console compartment door.



8. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH

  1. Engage the 3 guides, clip and 4 claws to install the upper No. 1 console panel garnish.



9. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH

  1. Engage the 2 guides, clip and 5 claws to install the upper No. 2 console panel garnish.



10. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    B271367

  1. Engage the 4 guides and 7 claws to install the lower center instrument panel finish panel.

  1. Close the glove compartment door.



11. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for Metal Finish Panel and Urethane Panel)

  1. Engage the 5 clips to install the No. 3 instrument cluster finish panel garnish.



12. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for Wood Panel and Bamboo Panel)

  1. Engage the 4 clips to install the No. 3 instrument cluster finish panel garnish.



13. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

  1. Engage the 4 claws and 2 guides to install the rear floor board upper No. 3 plate.



14. INSTALL DECK FLOOR BOX RH

  1. Engage the 6 guides.

  1. Install the deck floor box RH with the clip.



15. INSTALL REAR NO. 3 FLOOR BOARD

  1. Install the rear No. 3 floor board.



16. INSTALL REAR DECK FLOOR BOX

  1. Install the rear deck floor box.



17. INSTALL REAR NO. 2 FLOOR BOARD

  1. Install the rear No. 2 floor board.



18. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).