Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



1. CUSTOMIZE LIGHTING SYSTEM

  1. Customizing with the intelligent tester

    HINT:
    The following items can be customized.

    NOTICE:
    1. When the customer requests a change in a function, first make sure that the function can be customized.
    2. Be sure to make a note of the current settings before customizing.
    3. When troubleshooting a function, first make sure that the function is set to the default setting.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Utility / Customize / Illuminated Entry.

    5. Select the setting by referring to the table below.

      Illuminated Entry 
      Tester Display
      		Default
      		Content
      		Setting
      		Relevant ECU
      Lighting Time
      		15 s
      		Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC or IG).)
      		7.5 s, 15 s or 30 s
      		Main body ECU (Multiplex network body ECU)
      I/L when ACC OFF
      		ON
      		Lights up the power switch illumination, front interior lights and rear interior light when the power switch is turned from on (ACC or IG) to off.
      		ON or OFF
      I/L ON W/Door Key Unlock
      		ON
      		Lights up the power switch illumination, front interior lights and rear interior light when doors are unlocked using a mechanical key or door control transmitter.
      		ON or OFF
      Room Light when Aprchd
      		ON
      		Lights up the power switch illumination, front interior lights, rear interior light and footwell lights when a key enters any actuation area around the doors.
      		ON or OFF
      Inside Foot Light
      		ON
      		Lights up the footwell lights illumination.
      		ON or OFF
      Center Console Spot Light
      		ON
      		Lights up the center console spot light when the power switch is turned on (ACC or IG).
      		ON or OFF
      Light Control
      		ON
      		Dims (ON setting) or turns off (OFF setting) the footwell lights when all of the following conditions are met:
      1. The power switch is on (IG).
      2. The shift lever is moved to select a shift state other than park (P).
      3. All doors are closed.
      		ON or OFF
      Interior Light Control
      		ON
      		Lights up the front interior lights, footwell lights and center console spot light when the illuminated entry function is operating.
      		ON or OFF

  1. Customizing with the combination meter assembly

    HINT:
    1. Press and hold the DISP switch (steering pad switch assembly) when entering an item.
    2. Briefly press the DISP switch (steering pad switch assembly) when selecting an item.


    1. Turn the power switch on (IG).

    2. Enter the following menus: Settings / Vehicle Settings

    3. Select the setting by referring to the table below

      Display
      		Default
      		Content
      		Setting
      		Relevant ECU
      Int. Lights Off Adjustment
      		15 sec.
      		Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC or IG).)
      		15 sec., 7.5 sec., 30 sec. or OFF
      		Main body ECU (Multiplex network body ECU)

    4. Press and hold the DISP switch (steering pad switch assembly).

    5. The setting completion screen will be displayed.

    6. Return to the item selection screen.