AUTOMATIC TRANSMISSION ASSEMBLY > REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ENGINE UNDER COVER

3. REMOVE ENGINE UNDER COVER NO.2

4. REMOVE FRONT EXHAUST PIPE ASSEMBLY

5. REMOVE EXHAUST PIPE NO.1 SUPPORT BRACKET SUB-ASSEMBLY

6. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSEMBLY

7. DRAIN AUTOMATIC TRANSMISSION FLUID

8. REMOVE ENGINE UNDER COVER AIR GUIDE BRACKET

9. SEPARATE OIL COOLER INLET TUBE NO.1

10. REMOVE OIL COOLER OUTLET TUBE NO.1

11. REMOVE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

12. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY

13. REMOVE ENGINE REAR MOUNTING MEMBER

14. DISCONNECT WIRE HARNESS AND CONNECTORS

15. REMOVE FLYWHEEL HOUSING UNDER COVER

16. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

17. REMOVE ENGINE MOUNTING INSULATOR REAR NO.1

18. REMOVE TRANSMISSION CONTROL SHAFT LEVER RH

19. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY