FUEL INJECTOR > INSTALLATION

1. INSTALL FUEL INJECTOR SEAL

2. INSTALL FUEL INJECTOR

3. INSTALL NO. 1 FUEL DELIVERY PIPE

4. INSTALL NO. 2 FUEL DELIVERY PIPE

5. INSTALL NO. 3 FUEL PIPE

6. CONNECT NO. 2 FUEL PIPE

7. INSTALL HIGH PRESSURE SIDE FUEL PUMP

8. INSTALL NO. 2 FUEL PIPE

9. INSTALL NO. 1 FUEL PIPE

10. INSTALL FUEL PRESSURE PULSATION DAMPER

11. INSTALL INTAKE MANIFOLD

12. INSTALL INTAKE AIR SURGE TANK

13. CONNECT FUEL MAIN TUBE

14. CONNECT VENTILATION HOSE

15. CONNECT UNION TO CHECK VALVE HOSE

16. INSTALL ENGINE REAR COVER

17. CONNECT HEATER WATER INLET HOSE

18. CONNECT WATER BY-PASS HOSE

19. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

20. CONNECT NO. 2 VENTILATION HOSE

21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

22. ADD ENGINE COOLANT

23. CHECK FOR COOLANT LEAKAGE

24. CHECK FOR FUEL LEAKAGE

25. CHECK FOR ENGINE OIL LEAKAGE

26. INSTALL V-BANK COVER

27. INSTALL ENGINE ROOM SIDE COVER RH

28. INSTALL COOL AIR INTAKE DUCT SEAL

29. INSTALL ENGINE UNDER COVER

30. PERFORM INITIALIZATION

31. WARM UP ENGINE