FUEL INJECTOR > INSTALLATION

1. INSTALL FUEL INJECTOR ASSEMBLY

2. INSTALL NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY

3. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY

4. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

5. INSTALL INTAKE MANIFOLD

6. INSTALL NO. 2 FUEL PIPE ASSEMBLY

7. INSTALL ENGINE WIRE

8. INSTALL NO. 3 V-BANK COVER BRACKET

9. INSTALL NO. 2 V-BANK COVER BRACKET

10. INSTALL NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

11. INSTALL NO. 1 V-BANK COVER BRACKET

12. INSTALL NO. 4 V-BANK COVER BRACKET

13. INSTALL THROTTLE BODY ASSEMBLY

14. INSTALL INTAKE AIR CONNECTOR PIPE

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

16. CHECK FOR FUEL LEAKS

17. ADD COOLANT

18. CHECK FOR COOLANT LEAKS

19. INSTALL V-BANK COVER

20. INSTALL ENGINE ROOM SIDE COVER RH

21. INSTALL ENGINE ROOM SIDE COVER LH

22. INSTALL AIR INTAKE DUCT SEAL

23. PERFORM INITIALIZATION