TIMING BELT > INSTALLATION

1. INSTALL TIMING BELT

2. INSTALL NO. 1 CRANKSHAFT POSITION SENSOR PLATE

3. INSTALL NO. 1 TIMING BELT COVER

4. INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY

5. INSTALL IDLER PULLEY ASSEMBLY

6. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

7. INSTALL NO. 2 TIMING BELT COVER SUB-ASSEMBLY

8. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY

9. INSTALL NO. 3 TIMING BELT COVER SUB-ASSEMBLY LH

10. INSTALL OIL COOLER PIPE

11. INSTALL NO. 3 TIMING BELT COVER SUB-ASSEMBLY RH

12. CONNECT COMPRESSOR ASSEMBLY

13. INSTALL NO. 1 IDLER PULLEY BRACKET SUB-ASSEMBLY

14. INSTALL GENERATOR ASSEMBLY

15. INSTALL V-RIBBED BELT

16. INSTALL RADIATOR ASSEMBLY

17. CONNECT NO. 1 OIL COOLER OUTLET TUBE

18. CONNECT NO. 1 OIL COOLER INLET TUBE

19. CONNECT RADIATOR HOSE OUTLET

20. CONNECT RADIATOR HOSE INLET

21. INSTALL AIR CLEANER ASSEMBLY

22. INSTALL NO. 1 AIR CLEANER INLET

23. INSTALL INTAKE AIR CONNECTOR PIPE

24. INSTALL V-BANK COVER

25. REMOVE ENGINE ROOM SIDE COVER LH

26. REMOVE ENGINE ROOM SIDE COVER RH

27. REMOVE COOL AIR INTAKE DUCT SEAL

28. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

29. PERFORM INITIALIZATION

30. ADD ENGINE COOLANT

31. CHECK FOR ENGINE COOLANT LEAKS

32. INSTALL ENGINE UNDER COVER