STEERING GEAR > INSTALLATION

1. INSTALL POWER STEERING LINK ASSEMBLY

2. CONNECT TIE ROD END LH

3. CONNECT TIE ROD END RH

4. CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY NO.2

5. INSTALL FRONT SUSPENSION MEMBER PROTECTOR LOWER

6. INSTALL ENGINE UNDER COVER NO.2

7. INSTALL ENGINE UNDER COVER

8. INSTALL FRONT WHEELS

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

12. PERFORM INITIALIZATION

13. INITIALIZE ROTATION ANGLE SENSOR VALUE AND CALIBRATE TORQUE SENSOR ZERO POINT

14. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION (for 3UZ-FE)