WATER PUMP > INSTALLATION

1. CLEAN WATER PUMP ASSEMBLY

2. INSTALL WATER PUMP ASSEMBLY

3. INSTALL NO. 2 TIMING BELT IDLER SUB-ASSEMBLY

4. INSTALL WATER INLET HOUSING

5. INSTALL TIMING BELT

6. INSTALL NO. 1 CRANKSHAFT POSITION SENSOR PLATE

7. INSTALL TIMING GEAR COVER SPACER

8. INSTALL NO. 1 TIMING BELT COVER

9. INSTALL NO. 2 TIMING BELT COVER SUB-ASSEMBLY

10. INSTALL IDLER PULLEY ASSEMBLY

11. INSTALL NO. 3 TIMING BELT COVER SUB-ASSEMBLY RH

12. INSTALL NO. 3 TIMING BELT COVER SUB-ASSEMBLY LH

13. CONNECT OIL COOLER PIPE

14. INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY

15. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY

16. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

17. INSTALL COMPRESSOR ASSEMBLY

18. INSTALL GENERATOR ASSEMBLY

19. INSTALL V-RIBBED BELT

20. INSTALL RADIATOR ASSEMBLY

21. INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY

22. INSTALL HOOD LOCK ASSEMBLY

23. INSTALL HOOD LOCK CONTROL CABLE COVER

24. INSTALL RADIATOR SUPPORT OPENING COVER

25. INSTALL FRONT BUMPER COVER

26. DISCONNECT NO. 1 OIL COOLER OUTLET TUBE

27. DISCONNECT NO. 1 OIL COOLER INLET TUBE

28. CONNECT RADIATOR HOSE OUTLET

29. CONNECT RADIATOR HOSE INLET

30. ADD ENGINE COOLANT

31. CHECK FOR ENGINE COOLANT LEAKS

32. INSTALL AIR CLEANER ASSEMBLY

33. INSTALL NO. 1 AIR CLEANER INLET

34. INSTALL ENGINE ROOM SIDE COVER LH

35. INSTALL ENGINE ROOM SIDE COVER RH

36. INSTALL COOL AIR INTAKE DUCT SEAL

37. INSTALL V-BANK COVER SUB-ASSEMBLY

38. INSTALL ENGINE UNDER COVER

39. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

40. PERFORM INITIALIZATION