STEERING COLUMN ASSEMBLY (for 3UZ-FE) > INSTALLATION

1. HANDLING PRECAUTIONS FOR STEERING ACTUATOR ASSEMBLY

2. INSTALL STEERING ACTUATOR ASSEMBLY

3. INSTALL STEERING COLUMN ASSEMBLY

4. CONNECT STEERING ACTUATOR ASSEMBLY

5. INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY

6. INSTALL MAIN SHAFT LOWER DUST COVER

7. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

8. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

9. INSTALL TILT AND TELESCOPIC SWITCH

10. INSTALL STEERING COLUMN COVER

11. ADJUST SPIRAL CABLE SUB-ASSEMBLY

12. INSTALL STEERING WHEEL ASSEMBLY

13. INSPECT STEERING WHEEL CENTER POINT

14. INSTALL AIR DUCT NO.1

15. INSTALL INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER NO.1

16. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY NO.1

17. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1

18. INSTALL INSTRUMENT SIDE PANEL LH

19. INSTALL FRONT DOOR OPENING TRIM COVER LH

20. INSTALL FRONT DOOR SCUFF PLATE LH

21. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

22. INSTALL CONSOLE UPPER PANEL SUB-ASSEMBLY

23. INSTALL CONSOLE UPPER PANEL GARNISH FRONT

24. INSPECT STEERING WHEEL PAD

25. INSTALL STEERING WHEEL PAD

26. INSTALL STEERING WHEEL COVER LOWER NO.3

27. INSTALL STEERING WHEEL COVER LOWER NO.2

28. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

29. INSPECT SRS WARNING LIGHT

30. PERFORM INITIALIZATION

31. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION