ABSORBER CONTROL ECU > REPLACEMENT

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR SCUFF PLATE RH

3. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.2 (for LHD)

4. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1 (for RHD)

5. REMOVE ABSORBER CONTROL ECU

6. INSTALL ABSORBER CONTROL ECU

7. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.2 (for LHD)

8. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1 (for RHD)

9. REMOVE FRONT DOOR SCUFF PLATE RH

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. INSPECT ADAPTIVE VARIABLE SUSPENSION SYSTEM

12. PERFORM INITIALIZATION