BRAKE ACTUATOR (w/ VSC) > INSTALLATION

1. INSTALL ABS AND TRACTION ACTUATOR ASSEMBLY WITH BRACKET

2. INSTALL BRAKE MASTER WITH PLATE CYLINDER SUB-ASSEMBLY

3. INSTALL ENGINE ROOM RELAY NO.3 BLOCK

4. FILL RESERVOIR WITH BRAKE FLUID

5. BLEED BRAKE MASTER CYLINDER SUB-ASSEMBLY

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. BLEED BRAKE LINE

8. INSTALL FRONT WHEEL

9. INSPECT DTC

10. BLEED ABS AND TRACTION ACTUATOR ASSEMBLY

11. CHECK FLUID LEVEL IN RESERVOIR

12. INSPECT BRAKE FLUID LEAKAGE

13. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

14. INSTALL FRONT FENDER TO COWL SIDE SEAL LH

15. INSTALL FRONT FENDER TO COWL SIDE SEAL RH

16. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

17. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

18. INSTALL ENGINE ROOM SIDE COVER LH

19. INSTALL ENGINE ROOM SIDE COVER RH

20. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH

21. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH

22. INSTALL COOL AIR INTAKE DUCT SEAL

23. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

24. INSPECT VSC SENSOR SIGNAL

25. INSPECT ACTUATOR WITH INTELLIGENT TESTER

26. PERFORM INITIALIZATION