BRAKE ACTUATOR (w/ ECB) > REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE COOL AIR INTAKE DUCT SEAL

3. REMOVE ENGINE ROOM SIDE COVER RH

4. REMOVE ENGINE ROOM SIDE COVER LH

5. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH

6. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH

7. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

9. REMOVE FRONT FENDER TO COWL SIDE SEAL LH

10. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

11. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

12. PERFORM ACCUMULATOR PRESSURE ZERO DOWN

13. DISABLE BRAKE CONTROL

14. DRAIN BRAKE FLUID

15. REMOVE SKID CONTROL ECU ASSEMBLY

16. SEPARATE ENGINE ROOM RELAY NO.3 BLOCK

17. REMOVE FRONT WHEEL LH

18. REMOVE BRAKE ACTUATOR ASSEMBLY WITH ACTUATOR BRACKET