INSTALLATION
Removal / installation
| 1. INSTALL STEERING KNUCKLE |
Install the steering knuckle to the upper suspension arm with a nut.
- Torque:
- 87 N*m{ 887 kgf*cm , 64 ft.*lbf }
Install a new clip.
- NOTICE:
- If the holes for the clip are not aligned, further tighten the nut up to 60°.
| 2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY |
Install the steering knuckle to the lower ball joint with the 2 bolts.
- Torque:
- 120 N*m{ 1,224 kgf*cm , 89 ft.*lbf }
| 3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY |
Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.
- Torque:
- 69 N*m{ 702 kgf*cm , 51 ft.*lbf }
| 4. INSTALL FRONT DISC |
Align the matchmarks and install the front disc.
- HINT:
- When replacing the disc with a new one, select the installation position where the front disc has the minimum runout.
| 5. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY |
Install the brake caliper assembly and new No. 1 caliper plates to the steering knuckle with the 2 bolts.
- Torque:
- 78 N*m{ 795 kgf*cm , 58 ft.*lbf }
- NOTICE:
- Do not twist the front brake hose when installing the front disc brake caliper.
- Make sure that there are no foreign objects or damage to the threads of the bolts.
- Do not overtighten the bolts because the steering knuckle is made of aluminum and may be damaged easily.
- Do not twist the front brake hose when installing the front disc brake caliper.
| 6. CONNECT SPEED SENSOR FRONT |
Connect the speed sensor connector to the seed sensor front.
- NOTICE:
- Do not twist the sensor wire.
| 7. INSTALL FRONT WHEEL |
- Torque:
- 103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }
| 8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
| 9. CHECK ABS SPEED SENSOR SIGNAL |