Lexus IS250 · Service Manual ENGINE

INSTALLATION

Removal / installation


1. INSTALL TAIL EXHAUST PIPE BAFFLE SUB-ASSEMBLY

  1. Align the baffle with the protruding part of the tail exhaust pipe assembly as shown in the illustration.

  1. A109579E03
    Using a plastic hammer, uniformly tap the exhaust pipe baffle sub-assemblies onto the tail exhaust pipe assembly.


2. INSTALL EXHAUST PIPE DAMPER

  1. A100614E04
    Install the exhaust pipe damper with the 2 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }


3. INSTALL TAIL EXHAUST PIPE ASSEMBLY

  1. A125037E02
    Install the tail exhaust pipe assembly with the 6 exhaust pipe supports.


4. INSTALL FRONT EXHAUST PIPE ASSEMBLY

  1. A077857
    Using a vernier caliper, measure the free length of the compression springs.

    Minimum length:
    38.5 mm (1.516 in.)

    If the free length is less than the minimum, replace the compression spring.

  1. A109513E09
    Install a new gasket to the rear end of the front exhaust pipe.

    NOTICE:
    1. Be careful with the installation direction of the gasket.
    1. Do not reuse the gasket.
    1. To ensure a proper seal, do not use the tail exhaust pipe to force the gasket onto the front exhaust pipe.

      HINT:
      Using a plastic hammer, uniformly strike the gasket so that the gasket and front exhaust pipe are properly fit.

  1. Install 3 new gaskets and front exhaust pipe assembly.

    CAUTION:
    Do not reuse the gaskets.

  1. A125008
    Install the 2 bolts and 2 compression springs.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }

  1. A127822E01
    Install 4 new nuts and 4 bolts.

    Torque:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }

    NOTICE:
    Do not reuse the nuts.


5. INSTALL HEATED OXYGEN SENSOR

  1. A119092
    Before installing the heated oxygen sensors, twist the sensor wires counterclockwise 4 turns.

  1. A123663E02
    Using the SST, install the heated oxygen sensors to the front exhaust pipe.
    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf }

  1. After installing the sensors, check that the sensor wires are not twisted.
    If the sensor wires are twisted, reinstall them.

  1. A120539E05
    Install the grommets of the heated oxygen sensors.


6. INSTALL FRONT CENTER FLOOR BRACE

  1. C104834
    Install the front center floor brace with the 4 bolts.

    Torque:
    7.4 N*m{ 75 kgf*cm , 65 in.*lbf }


7. INSTALL REAR NO. 1 FLOOR PANEL BRACE

  1. A121036
    Install the rear No. 1 floor panel brace with the 4 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }


8. CHECK FOR EXHAUST GAS LEAKS
If exhaust gas is leaking, tighten the related parts to stop the leak. Replace damaged parts as necessary.
← REMOVALPARTS LOCATION →