Lexus IS250 · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection


INSPECT TOE CONTROL LINK

  1. Secure the rear upper No. 2 control arm in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. G033364
    Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.

  1. Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the 5th turn.

    Turning torque:
    0.9 to 3.5 N*m (9.17 to 35.7 kgf*cm, 0.6 to 2.5 ft.*lbf) or less

    If the value is not within the specified range, replace the rear suspension toe control link with a new one.

  1. Check the dust boot for cracks or grease leakage.

← REMOVALINSTALLATION →