Lexus IS250 · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation


1. REMOVE REAR WHEEL

2. REMOVE TOE CONTROL LINK

  1. C128031
    Disconnect the skid control sensor connector.

  1. Remove the bolt and separate the skid control sensor wire from the toe control link.

  1. Remove the nut on the axle carrier side.

  1. C128032E01
    Using SST, disconnect the toe control link.
    SST
    09628-00011  

    NOTICE:
    1. Securely tie the string of the SST to the vehicle.
    2. Do not damage the dust cover.
    3. Securely set the SST on the spacer of the axle carrier.
    4. If the spacer of the axle carrier comes off, replace the axle carrier with a new one.

  1. C128033E01
    Put matchmarks on the rear No. 2 suspension toe adjust plate and rear suspension member.

  1. Remove the nut, rear suspension toe adjust cam assembly, rear No. 2 suspension toe adjust plate, and toe control link.

← COMPONENTSINSPECTION →