Lexus IS250 · Service Manual RESTRAINTS

REMOVAL

Removal / installation


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting cable to prevent the airbag deployment.


2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

3. REMOVE LOWER NO. 3 STEERING WHEEL COVER

  1. C122397
    Using a screwdriver, remove the steering wheel No.3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.


4. REMOVE LOWER NO. 2 STEERING WHEEL COVER

  1. C122398
    Using a screwdriver, remove the steering wheel No.2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.


5. REMOVE STEERING PAD

  1. C122396E01
    Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.

  1. C122394
    Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.


6. REMOVE STEERING WHEEL ASSEMBLY
For Manual Tilt (Click here)
For Power Tilt and Power Telescopic (Click here)

7. REMOVE STEERING COLUMN COVER
For Manual Tilt (Click here)
For Power Tilt and Power Telescopic (Click here)

8. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR

  1. C122402E01
    Disconnect the connectors from the spiral cable with steering sensor.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Disengage the 3 claws and remove the spiral cable with steering sensor.


9. SEPARATE SPIRAL CABLE

  1. C110478E02
    Disengage the 6 claws and separate the spiral cable.

← COMPONENTSINSPECTION →