Lexus IS250 · Service Manual RESTRAINTS

REMOVAL

Removal / installation

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.


3. REMOVE REAR SEAT CUSHION ASSEMBLY

  1. B121659E01
    Detach the 2 front hooks of the seat cushion from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame deforms easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat for the other hook.

  1. Detach the 2 rear hooks of the seat cushion from the seatback.

  1. Remove the seat cushion.


4. REMOVE REAR SEAT HEADREST ASSEMBLY

5. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY

6. REMOVE REAR SEATBACK ASSEMBLY

  1. B105996E02
    Using a screwdriver, detach the claws to open the cap of the 3 rear seat shoulder belt guides.

  1. B120546E02
    Using a screwdriver, detach the claw to open the cap of the 3 rear seat shoulder belt guides.

  1. B121660
    Remove the 4 bolts and rear seatback assembly.


7. REMOVE REAR DOOR SCUFF PLATE

  1. B125386E01
    Put protective tape around the rear door scuff plate.

  1. Using a moulding remover, disengage the 2 clips.

  1. B125387
    Disengage the 5 claws and remove the the rear door scuff plate LH.


8. REMOVE REAR SEAT SIDE GARNISH

  1. B125408
    Disengage the 5 claws and remove the rear seat side garnish LH.


9. REMOVE REAR AIRBAG SENSOR

  1. C122434
    Disconnect the connector.

  1. Remove the bolt and rear airbag sensor.

← ON-VEHICLE INSPECTIONINSTALLATION →