DISASSEMBLY
Removal / installation
| 1. REMOVE REAR WHEEL |
| 2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY |
Remove the 2 bolts and separate the rear disc brake caliper assembly.
- NOTICE:
- Hang the caliper with wire or equivalent.
Remove the No. 1 caliper plate (2 pieces).
| 3. REMOVE REAR DISC |
Release the parking brake.
Put matchmarks on the rear disc and rear axle hub.
Remove the rear disc.
- HINT:
- If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns smoothly.
| 4. REMOVE NO. 2 PARKING BRAKE SHOE RETURN SPRING |
Using SST, remove the No. 2 parking brake shoe return spring.
- SST
- 09703-30011
| 5. REMOVE NO. 1 PARKING BRAKE SHOE RETURN SPRING |
Using SST, remove the No. 1 parking brake shoe return spring.
- SST
- 09703-30011
| 6. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET |
Slide the parking brake shoe, and remove the parking brake shoe adjusting screw set.
| 7. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY |
Using SST, remove the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin.
- SST
- 09718-00010
Remove the No. 2 parking brake shoe assembly.
- HINT:
- Use the service hole to retain the No. 1 hold down spring pin with your finger.
| 8. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY |
Using SST, remove the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin.
- SST
- 09718-00010
Remove the No. 1 parking brake shoe assembly.
- HINT:
- Use the service hole to retain the No. 1 hold down spring pin with your finger.
| 9. REMOVE PARKING BRAKE SHOE LEVER |
Remove the parking brake shoe lever.
| 10. REMOVE PARKING BRAKE ANCHOR BLOCK |
Remove the rear axle hub and bearing assembly (Click here).
Remove the 2 nuts, cable support bracket and parking brake anchor block.