Lexus IS250 · Service Manual CRUISE CONTROL SYSTEM

REMOVAL

Removal / installation


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation (Click here).


2. REMOVE NO. 2 LOWER STEERING WHEEL COVER

3. REMOVE NO. 3 LOWER STEERING WHEEL COVER

4. REMOVE STEERING PAD

  1. C122396E01
    Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.

  1. C122394
    Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.


5. REMOVE CRUISE CONTROL MAIN SWITCH

  1. Disconnect the connector.

  1. E115066
    Remove the 2 screws and the cruise control main switch.

← COMPONENTSINSPECTION →