Lexus IS250 · Service Manual STEERING

INSTALLATION

Removal / installation


1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU

  1. C105553
    Install the multiplex tilt and telescopic ECU with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

  1. Connect the connector to the multiplex tilt and telescopic ECU.

    NOTICE:
    1. The connectors on both ends of the wire harness between the telescopic motor and ECU are the same shape.
    2. When installing them, connect the connectors of the same color.


2. INSTALL STEERING LOCK ACTUATOR ASSEMBLY

  1. Temporarily install the steering lock actuator assembly with 2 new tapered-head bolts.

  1. C105552
    Tighten the 2 tapered-head bolts until the bolt heads break off.


3. INSTALL STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic)

HINT:
Refer to the instructions for Installation of the steering column assembly (for Power Tilt and Power Telescopic) (Click here).

← REMOVALPRECAUTION →