Lexus IS250 · Service Manual STEERING

REMOVAL

Removal / installation


1. REMOVE STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic)

HINT:
Refer to the instructions for removal of the steering column assembly (for Power Tilt and Power Telescopic) (Click here).


2. REMOVE STEERING LOCK ACTUATOR ASSEMBLY

  1. Using a center punch, mark the center of the 2 tapered-head bolts.

  1. Using a 3 to 4 mm (0.12 to 0.16 in.) drill, drill a hole in the 2 bolts.

  1. C105551E01
    Using a screw extractor, remove the 2 bolts and steering lock actuator assembly from the steering column assembly.


3. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU

  1. C105553
    Disconnect the connector from the multiplex tilt and telescopic ECU.

  1. Using a screwdriver, remove the 2 screws and multiplex tilt and telescopic ECU.

← COMPONENTSINSTALLATION →