TERMINALS OF ECU
System information
| MULTIPLEX TILT & TELESCOPIC ECU |
| Symbols (Terminal No.) |
Wiring Color |
Terminal Description |
Condition |
Specified Condition |
| TEM+ (A-2) - GND (J28-11) |
- (Not available) - W-B |
Telescopic motor output |
|
10 to 14 V |
| Telescopic motor is not operating |
Below 1 V |
|||
| VCE (A-3) - E2 (A-5) |
- (Not available) |
Telescopic sensor power source |
Engine switch on (IG) |
8 to 16 V |
| TES (A-4) - E2 (A-5) |
- (Not available) |
Telescopic sensor signal |
Telescopic motor is operating |
Pulse generation HI: 8 to 16 V LOW: 0 V |
| E2 (A-5) - Body Ground |
- (Not available) - Body Ground |
Telescopic sensor ground |
Always |
Below 1 V |
| TEM- (A-6) - GND (J28-11) |
- (Not available) - W-B |
Telescopic motor output |
|
10 to 14 V |
| Telescopic motor is not operating |
Below 1 V |
|||
| TIM- (J28-1) - GND (J28-11) |
V - W-B |
Tilt motor output |
|
10 to 14 V |
| Tilt motor is not operating |
Below 1 V |
|||
| +B (J28-2) - GND (J28-11) |
SB - W-B |
Motor power source |
Always |
10 to 14 V |
| MPX1 (J28-5) - GND (J28-11) |
GR - W-B |
Multiplex communication |
Engine switch on (IG) |
Below 1 V |
| VCI (J28-6) - E1 (J28-17) |
G - O |
Tilt sensor power source |
Engine switch on (IG) |
8 to 16 V |
| TIS (J28-7) - E1 (J28-17) |
R - O |
Tilt sensor signal |
Tilt motor is operating |
Pulse generation HI: 8 to 16 V LOW: 0 V |
| IG (J28-8) - GND (J28-11) |
B - W-B |
IG signal / IG power source |
Engine switch on (IG) |
10 to 14 V |
| Engine switch off |
Below 1 V |
|||
| ECUB (J28-9) - GND (J28-11) |
LG -W-B |
ECU power source |
Always |
10 to 14 V |
| TIM+ (J28-10) - GND (J28-11) |
P - W-B |
Tilt motor output |
|
10 to 14 V |
| Tilt motor is not operating |
Below 1 V |
|||
| GND (J28-11) - Body ground |
W-B - Body Ground |
ECU ground |
Always |
Below 1 V |
| E1 (J28-17) - Body Ground |
O - Body Ground |
Tilt sensor ground |
Always |
Below 1 V |