Multi-display Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the multi-display.

WIRING DIAGRAM

INSPECTION PROCEDURE

1. INSPECT MULTI-DISPLAY

1. Disconnect the multi-display connector J50.

2. Measure the resistance according to the value(s) in the table below.

   Standard resistance:

   Tester connection	Condition	Specified condition
   GND1 - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage:

   Tester connection	Condition	Specified condition
   +B1 - GND1	Always	10 to 14 V
   ACC - GND1	Engine switch on (ACC)	10 to 14 V
   IG - GND1	Engine switch on (IG)	10 to 14 V

NG	REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE