INSPECTION

1. Measure the resistance according to the value(s) in the table below.
   

   Resistance:

   Tester Connection	Switch Position	Specified Condition
   1 (RV) - 6 (SW)	OFF: Front RH Vol: 0	Below 2.5 kΩ
   	OFF: Front RH Vol: 3	Below 376 Ω
   2 (REL1) - 11 (SW)	OFF: Front LH Vol: 0	Below 2.5 kΩ
   	OFF: Front LH Vol: 3	Below 376 Ω
   7 (BLLH) - 10 (SVSG)	OFF: Front RH Vol: 0	Below 1.1 kΩ
   	OFF: Front RH Vol: 3	Below 111 Ω
   8 (SVS5) - 10 (SVSG)	Always	Below 770 - 1.43 kΩ
   9 (BLRH) - 10 (SVSG)	OFF: Front LH Vol: 0	Below 1.1 kΩ
   	OFF: Front LH Vol: 3	Below 111 Ω

Inspect seat heater switch indicator operation.

1. Apply battery voltage and check operation of the switch, as shown in the table below.
   

   Standard:

   Measurement Condition	Condition	Specified Condition
   Battery positive (+) → Terminal 5 (IG) Battery negative (-) → Terminal 12 (E)	Seat heater switch ON	Indicator comes on

Inspect seat heater switch illumination.

1. Apply battery voltage and check operation of the switch, as shown in the table below.
   

   Standard:

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 4 (ILL+) Battery negative (-) → Terminal 3 (ILL-)	Illumination comes on