INSPECTION
Inspection
| INSPECT SHIFT PADDLE SWITCH |
Disconnect the switch wire connector from the transmission shift switch.

Measure the resistance between each terminal when the paddle shift is moved to each position.
If the resistance value is not as specified, replace the shift paddle switch.Standard resistance Paddle Shift Position
Tester Connection
Specified Condition
Pull continuously "+" (Up shift)
SFTU - ECC
Below 1 Ω
Release "+" (Up shift)
SFTU - ECC
10 kΩ or higher
Pull continuously "-" (Down shift)
SFTD - ECC
Below 1 Ω
Release "-" (Down shift)
SFTD - ECC
10 kΩ or higher
